The process for adding Relays and Buttons to a Gateway is the same.
1 - While on the Gateway page, select "Equipment +"
2 - Scan a sensor QR code (or manually enter the code - not recommended).
3 - Complete all the required information in the form.
Is this equipment cardio or strength equipment?
Cardio - Is this equipment Self Powered or Wall Powered?
Strength - Is this equipment Selectorized or Plate-Loaded?
What type of equipment is this? For example, a Treadmill, Elliptical, Chest Press, etc.
The facilitiy's label or identifier for equipment.
The equipment brand such as Precor or Life Fitness.
The equipment serial number. This can be scanned using the barcode scanner.
This phtoo should show the front of the equipment and clearly show any peripherals and console type.
Station is used to group sensors together for use on multi unit stations, such as multi cable stations.
Mode (Relay Only):
The mode refers to the Csafe mode. The default mode should always be 1. Only change this setting if instructed to by ecofit support or if the equipment is listed as Mode 7 in the Model Catalog.
Sensitivity (Button Only):
This sets the threshold sensitivity for the Button. High sensitivity means that the Button will be more sensitive to movement.
Add Notes (Optional):
Add any notes about the equipment if necessary.
Add Offset (Optional):
Add any existing hours or miles that the equipment has collected.
4 - Select Save.
5 - Once all equipment has been registered, update the Gateway.
Follow the instructions here to update the gateway: Update Gateway
Equipment cannot be verified unless the gateway is up-to-date