Tools Required:
Mounting Kit | The mounting kit contains everything you need to mount a Tracker. Mounting kits can be purchased from Ecofit directly, just email support@myecofit.com. |
Installation App | To reconfigure the Tracker once Remounted. |
Small Magnet | To put the Tracker into configuration mode. |
Re-mounting a Tracker is simple but it is important to follow all steps to ensure that proper functionality is restored.
1 - Clean away the old adhesive.
As best you can, remove the old adhesive from the Tracker and clean the bottom well with alcohol. If the old adhesive cannot be removed, clean it well with alcohol and remove any foreign objects such as grit or dust. Allow the surface to dry completely. |
2 - Apply a new strip of mounting adhesive to the bottom of the Tracker, pressing down firmly to ensure contact.
Replacement adhesive strips are included in the Mounting Kit. |
3 - Locate the linked equipment by searching for the Tracker Reference Code on the facility page of the Asset Portal.
Where to mount the Tracker:
Full Tracker mounting instructions can be found here.
4 - Clean the mounting area of the equipment well with Alcohol and allow to dry completely.
Ensure that there is no residue or foreign material (such as old adhesive or grease) present on the mounting surface.
5 - Apply 2-3 layers of Adhesive Primer to mounting surface and allow to dry completely.
The primer will promote a very strong adhesion to the equipment.
6 - Remove the adhesive cover and mount the Tracker over the dried primer.
Ensure that you apply in excess of 15lbs of pressure for at least 10 seconds when mounting the Tracker. This ensures that the maximum bond is achieved.
7 - Reconfigure the Tracker using the Install App.
This ensures that the Tracker has been properly formatted to the equipment.
Comments
0 comments
Please sign in to leave a comment.